3.2 Pre-Coated Film Lamination
In pre-coated film lamination, a thin layer of PVC paste is applied to the surface of the PVC film before it is laminated to the base fabric. The paste acts as a bonding layer and raises the bond strength between the film and the fabric, so the process can be seen as an enhanced form of hot lamination. It is one of the routes used to make PVC laminated fabric with better peel strength.
| Parameter | Pre-Coated Film Lamination |
|---|---|
| Paste Weight | No more than 30 g per side |
| Purpose | Improves the bond strength between the PVC film and the base fabric |
| Relation to Other Processes | Can be seen as an enhanced form of hot lamination |
| Typical Peel Strength | Around 60 N |
| On Dense Base Fabrics | Pre-coating alone may give only a limited improvement in peel strength |
The gain depends on the base fabric. On open and medium-density fabrics, the paste fills the contact points between the film and the yarns well. On dense base fabrics, where the face and back PVC layers have little room to meet, pre-coating alone may not lift peel strength enough, and impregnation (3.3) is the better route.
3.2.1 Pre-Coated Film vs. Impregnation
Pre-coated film lamination improves the bond, but because the paste stays on the film rather than soaking into the yarns, the finished fabric behaves differently from an impregnated one:
| Comparison | Pre-Coated Film Lamination | Impregnation |
|---|---|---|
| Hand Feel | Soft and limp | Firmer, with more body |
| Back of the Fabric | Smooth, with no granular texture | Granular texture |
| Base Fabric | Yarns are not impregnated with paste | Yarns are soaked through with paste |
| Cut Edges in Rain | Exposed cut edges can wick water | Paste blocks water from traveling along the yarns |
| Peel Strength | Better than plain hot lamination; limited gain on dense fabrics | Better, including on dense fabrics |
Wicking is the point buyers most often overlook. Because the base fabric is not impregnated, water can creep into an exposed cut edge and travel along the yarns by capillary action. For truck covers, outdoor covers and other products whose cut edges face rain, impregnation gives better protection; the anti-wicking options are covered in 2.1.
3.2.2 When Pre-Coated Film Lamination Fits
Pre-coated film lamination suits products that need a better bond than hot lamination can give, a soft hand and a smooth back, on base fabrics that are not too dense. When the base fabric is dense, the peel requirement is high, or the cut edges will be exposed to water, we recommend impregnation instead. Tell us the base fabric and end use, and we will choose the route and confirm the peel strength on a trial sample.